Dish settings problem with CW 800

[jayman2]

Merry X-Mas to all. I just got a CW 800 this past Friday. I'm replacing my CS 6000. I did my best setting it up and I installed and enabled the latest patch. I am getting everyting on nimiq 2, but I can't get anything to come in on dn 119. I'm recieving a stronger signal on 119 and I scanned in the channels, but they're all Scrambled . I see from my list on 119, that these are the channels that I really want to view.

I'm using a motorized dish. I tried to set up my CW as close to my CS as possible, but the menus are a little different. With my CS, I was able to get dn and nimiq. With my dish, there are about 8 or 9 sats in range. I could scan and view any or all of them with my CS. Is there a reason why I can have a strong signal, scan sats with my CW 800 and have them all Scrambled , except for nimiq. Also, in the Antenna Settings menu, on the bottom of each satellite page it says "Found:42.NImiq 1 (91.0W)". Should it be saying this for all sats, dn and b3v?

I really prefer my CW over my CS because of the fast updates/fixes and the USB function. Does anyone know how I can solve this problem?

[TD52]

well what are your settings for 119 and 110 you said you have the patch on...what version bn are your using for your cw800pvr?
do you have the auto roll on?
and have you scanned each satellite separately before you did a full scan...that will look for satellites

[jayman2]

For 110 I have:
Transponder - 12224/v/20000/5/6
lnb freq. - 11250
lnb type - ocs-dp
22KHz - on
Diseqc # - off
legacy sw - off
motorized sys - usals

I have the same settings for 119 also,
I'm using bin v1.38 and I have it enabled and auto roll is on.
I scanned each satellite separately, but I did't know that you were supposed to do a full scan to look for satellites.
Also, is it supposed to say "Found:42.NImiq 1 (91.0W)", on the bottom of each satellite page?

Thanks in advance.

[vrisk]

Try Diseqc # - LNB 1 (or LNB2)
Also on mine 22KHz - off