help

[mauriciov5k]

which router i need to use to read tha dogle i used so far dlink g trend n an tha linksys g an so far no luck to get the router read the dongle thanks for any help i can get fta concept

[ufcwatcher]

It should work with a linksys router but not many have that receiver here. I would suggest to read the setup guide for your receiver as not many from the staff of ftaconcept have that receive with the dongle. If we did we could help you better.

[jcghound]

Recheck your setup settings on how to enable the dongle use. Most DLink and Linksys routers work with the dongle.

[buddyjh]

Here ya go man I did mine like this and it set up perfectly...server comes and goes though but if you follow this it should work:

c/p

For the nano only not the nano2

File for use with dongle system for cnx nano

How To Load Dongle File For CNX Nano
IX-Net Dongle Files
IX-NET dongles work on CNX Receivers.

Instructions

1. Upgrade the nano with latest NAN upgrade file which for now is 4.17

2. After the upgrade goto Menu -> Accessory ->RS-232 Mode and select Type to Dongle.

3. Connect the dongle to RS-232 Port.

4. Connect the Lan line to the dongle.

5. After 10 seconds(dongle booting time and IP setting time) go to Menu -> System Information
very bottom line it should show the dongle software version

6. If it shows the version it means connected but if it shows Unknown it means not connected.

7. When Connected go to USB Menu and select the DGL(dongle upgrade file.).

A. It should start to upgrade the dongle.

B. After the upgrade please check the System Information in the Menu and make sure the upgraded version is IX-X00-E A2.0.8 T1217.DGL...If this file doesn't work go back to the file IX-X00-E A2.0.6 T1927.DGL. You can find these files in the cnx dongle file sections here.

8. Go to Menu Accessory -> RS-232 Mode and select Network IP Setup.

9. Will read the dongle IP information and show. If the IP information shows Auto or Maual it means the IP setup is correct.

A. If it shows Not Used it means setup has not been done. Check the lan line and if no problem please select Auto and Apply.

B. IF you dont see IP information after 20-30 seconds it is the lan line problem.

10. When it has been set up correctly go to Bev/Dish N3 Channel and the dongle will try to connect to the server. Press OK

A. Dish and Bev should be working for now. More channels to come as we work on it.

B. If no screen shows up it mean there is a problem on the server or on the software.

Note: You may have to put it on channel 200 and wait for awhile for it to work.

[mauriciov5k]

thanks... for yuor quik respons.. i goin to try it again an i lets your kwno