Quantcast FTA Bin Files Servers LinkBox Pinwheel DreamLink Jynxbox IPTV - View Single Post - Could use some help with server installation info
View Single Post
Old 01-14-2016, 11:23 AM   #7
who-me
VIP Member
 
who-me's Avatar
 
Join Date: Jun 2010
Posts: 2,566
Reputation: 29859433
who-me has a reputation beyond reputewho-me has a reputation beyond reputewho-me has a reputation beyond reputewho-me has a reputation beyond reputewho-me has a reputation beyond reputewho-me has a reputation beyond reputewho-me has a reputation beyond reputewho-me has a reputation beyond reputewho-me has a reputation beyond reputewho-me has a reputation beyond reputewho-me has a reputation beyond repute

Default

Well, This time I am putting the notes in the owners manual.
Toggling did nothing. I noticed you said highlight. So how do you highlight with a remote?
So I put it on the IP and pushed OK. To my surprise up comes the letters & numbers etc.
Getting to save it was another problem.
After entering you normally would go to OK and click on OK. It saved it.
No it did not. When I brought it back up. just the IP again and nothing else.
This time after entering I pushed the blue button for save. Works.
So now why does it not connect. Same sever info in my SV800 on the bench connected to the internet using the power line modules.
8000 has no problem. The Freesat 800 does not like the ones I am using.
I have two modules. Using the same two no go. Using another two no go.
Using one of each make. It works. Go figure.
ON last question. There was a file to make it an I-LInk and then a #9 file to fix those problems and now should be fine for that bin file.
Is there a reason why I should load that file?
Does it do anything better?
Thanks
You were a real help.
who-me is offline   Reply With Quote